Standard Specifications

For Classic E By-Pass

Units shall be Classic E By-Pass tub or shower enclosures, as manufactured by Southeastern Aluminum Products, Inc., Jacksonville, FL.

Materials

Structural metal shall be extruded aluminum – 6463 alloy, T-6 temper – with a brite dip or satin anodized finish. Glass shall be Safety Tempered Glass to meet or exceed ANSI 97.1–2004-UA and/or CPSC 16CFR–1201-III requirements.

Construction

Enclosure panels shall be constructed of aluminum frames with 45° mitered corners, fastened with heavy corner screws. Frames shall allow 5/16 inch minimum penetration of glass with glass set in extruded vinyl channels. Each enclosure panel shall have two extruded aluminum hangers – 6463 alloy, T-6 temper. Each hanger has a suspension roller with encased ball bearings and five individual adjustment settings. Panels shall also have two bottom nylon guides to secure panels to sill track, and a single extruded towel bar.

Installation

Installation shall be made according to Manufacturer’s instructions and drawings included with each unit. Headers and sill tracks shall be shipped extra length to allow exact cutting at time of installation.

Limited Warranty

Southeastern Aluminum's products are guaranteed for a period of one year from date of purchase against defects in material or workmanship. This warranty is limited to repair or replacement of defective units at the option of Southeastern Aluminum Products, Inc. This warranty is void if the unit shows any signs of physical abuse or neglect or there is evidence of improper installation. Southeastern Aluminum Products, Inc. is not responsible for any damages or injury to persons or property except for replacement or repair of defective units.